Mechanical Properties Evaluation of a Recycled Flax Fiber-reinforced Vinyl Ester

Abstract

Flax fiber-vinyl ester composites are milled and mixed with virgin matrices to produce recycled composites. The effect of this powder incorporation on the mechanical properties of a thermosetting matrix (vinyl ester) and a thermoplastic matrix (polypropylene) is studied.

In the case of thermosetting matrix, flexural and tensile strength decrease with the addition of powder. For filler contents higher than 50 vol%, the strength reaches a constant value. Flexural and Young’s moduli remain constant for different powder contents.

In the case of thermoplastic matrix, strength and modulus decrease when powder is replaced by fibers. Both, fibers and powder act as reinforcement as moduli increase. Impact properties are improved with the addition of powder and fibers in comparison with the pure matrix.

Keywords

natural fibers recycling composites vinyl ester mechanical properties

References

Cunliffe, A.M. , Jones, N. and Williams, P.T. (2003). Recycling of Fiber-reinforced Polymeric Waste by Pyrolysis: Thermo-gravimetric and Bench-scale Investigations , J. Anal. Appl. Pyrolysis, 70: 315-338 .

Drozdov, A.D. , Al-Mulla, A. and Gupta, R.K. (2004). The Effect of Recycling on the Time-dependent Behavior of Polycarbonate Reinforced with Short Glass Fibers , Composites Science and Technology, 64: 129-144 .

Halada, K. (2003). Progress of Ecomaterials toward a Sustainable Society , Current Opinion in Solid State and Materials Science, 7: 209-216 .

Hans-Georg, E. (1997). In: Bock, B. (ed.), An Introduction to Polymer Science, Weinheim, Federal Republic of Germany .

Cunliffe, A.M. and Williams, P.T. (2003). Characterisation of Products from the Recycling of Glass Fiber Reinforced Polyester Waste by Pyrolysis , Fuel, 82: 2223-2230 .

Kennerley, J.R. , Kelly, R.M. , Fenwick, N.J. , Pickering, S.J. and Rudd, C.D. (1998). The Characterisation and Reuse of Glass Fibers Recycled from Scrap Composites by the Action of a Fluidised Bed Process , Composites Part A, 29A: 839-845 .

Cavalieri, F. and Padella, F. (2002). Development of Composite Materials by Mechanochemical Treatment of Post-consumer Plastic Waste , Waste Management, 22(8): 913-916 .

Rombary, G. , Karger-Kocsis, J. and Czigany, T. (2003). Tensile Fracture and Failure Behaviour of Thermoplastic Starch with Unidirectional and Cross-ply Flax Fiber Reinforcement , Macromol. Mater. Eng., 288: 699-707 .

Piggott, M.R. (1980). Load Bearing Fiber Composites, Pergamon, Oxford .

10.

Moloney, A.C. , Kausch, H.H. , Kaiser, T. and Beer, H.R. (1987). Parameter Determining the Strength and Toughness of Particulate Filled Epoxide Resins , Journal of Material Science, 22: 381-393 .

11.

Bezeredi, A. , Demjen, Z. and Pukanszky, B. (1998). Fracture Resistance of Particulate Filled Polypropylene , Die Angewandie Makromoleculare Chemie, 256: 61-68 .