Punch-less and die-less sheet hydroforming process for manufacturing of serpentine-shaped micro-channels in ultra-thin sheets

In the present work, novel serpentine-shaped micro-channels were successfully fabricated in ultra-thin sheets of AA1050, C101, and SS304 materials using the sheet hydroforming (SHF) process. In-house fabrication methods, namely punch-less SHF and die-less SHF processes were designed and developed on a 20-t press to manufacture these channels. The finite element (FE) modeling of both processes was developed for the prediction of the deformation behavior of these sheets. The elasto-plastic FE models incorporated the elastic properties, Barlat 89 anisotropic yield model, and Hollomon hardening law for all the three sheets, and their corresponding forming limit diagrams (FLDs) were implemented as damage criteria. It was observed that the maximum pressure was 28 MPa and 32 MPa for the punch-less and die-less SHF process, respectively. The manufacturability of the hydroformed channels was examined through channel depth, aspect ratio, and thickness distribution. The average channel depth and aspect ratio were found to be higher in the case of the die-less SHF compared to punch-less SHF. The failure occurred in the AA1050 channel under plane strain deformation mode near the die corner region and punch corner region for punch-less and die-less SHF processes, respectively, indicated by a sudden dip in the thickness distribution profile. Moreover, the surface quality of the formed channels was investigated through surface roughness value, and this was further correlated with effective plastic strain incurred in the deformation process. It was observed that the surface roughness of the deformed channels fabricated by the punch-less SHF process was lower than those formed through the die-less SHF process in the present study.