Large eddy simulation of the flow energy dissipation in the blade channels of a stalled pump impeller

Abstract

Pump impellers usually work with the rotating stall phenomenon. The performance will be strongly affected by the undesirable flow. Understanding the features of flow energy dissipation is very important. In this study, large eddy simulation is conducted for the turbulent flow field based on a typical 6-blade pump impeller with “alternating stall” phenomenon. The stalled channels and well-behaved channels alternatively and stably distribute. Compared with the experimental data, the numerical simulation is proved accurate. In the well-behaved channel, flow pattern is relatively smooth. In the stalled channel, flow is completely blocked by several stall cells. Vortex shedding is well predicted mainly in three regions including the leading-edge region of stalled channel, the outlet region of stalled channel, and the blade suction side region of well-behaved channel. Turbulence kinetic energy is high in these regions. High flow energy dissipation is found among shedding vortexes due to flow-flow interaction and in the near-wall region because of flow-wall interaction. In the core region of vortexes, flow energy dissipation is not that high. The flow-flow interaction and the flow-wall interaction are two main sources of flow energy dissipation. In the well-behaved impeller blade channel with smooth flow pattern, the flow energy dissipation is mainly caused by flow-wall interaction. On the contrary, in the stalled impeller blade channel with vortical flow pattern, the flow energy dissipation is mainly caused by flow–flow interaction. The large eddy simulation-based study will be very helpful in enhancing the performance of pump impellers especially with the rotating stall phenomenon.

Keywords

flow energy dissipation large eddy simulation centrifugal impeller vortical flow rotating stall

Get full access to this article

View all access options for this article.

References

Emmons

Pearson

Grant

. Compressor surge and stall propagation. Trans ASME 1955; 77: 455–469.

Widmer

Staubli

Ledergerber

. Unstable characteristics and rotating stall in turbine brake operation of pump-turbines. J Fluids Eng 2011; 133(4): 041101.

Hasmatuchi

Farhat

Roth

, et al. Experimental evidence of rotating stall in a pump-turbine at off-design conditions in generating mode. J Fluids Eng 2011; 133(5): 051104.

Zhou

Wang

Mou

. Investigation of rotating stall characteristics in a centrifugal pump impeller at low flow rates. Eng Computations 2017; 34(6): 1989–2000.

Liu

Zhang

. A review of rotating stall of pump turbines. J Hydroelectric Eng 2015; 34(11): 16–24.

Shiomi

Kaneko

Setoguchi

. Natures of rotating stall cell in a diagonal flow fan. J Therm Sci 2005; 14(1): 9–14.

Miura

Yamashita

Takeuchi

, et al. Numerical and experimental study on rotating stall in industrial centrifugal compressor. J Turbomach 2021; 143(8): 081008.

Feng

Yang

, et al. Rotating stall characteristics in the vaned diffuser of a centrifugal pump. Ocean Eng 2021; 229: 108955.

Song

Liu

. Experimental investigation of floor-attached vortex effects on the pressure pulsation at the bottom of the axial flow pump sump. Renew Energ 2020; 145: 2327–2336.

10.

Walters

Cokljat

. A three-equation eddy-viscosity model for Reynolds-Averaged Navier-Stokes simulations of transitional flow. J Fluids Eng 2008; 130(12): 121401.

11.

Song

Liu

Luo

. Influence of inlet vortex on pressure pulsation in axial flow pump unit. Trans Chin Soc Agric Machinery 2018; 49(2): 11381–12119.

12.

Moeng

C-H

. A large-eddy-simulation model for the study of planetary boundary-layer turbulence. J Atmos Sci 1984; 41(13): 2052–2062.

13.

Posa

Lippolis

. A LES investigation of off-design performance of a centrifugal pump with variable-geometry diffuser. Int J Heat Fluid Flow 2018; 70: 299–314.

14.

Mcmullan

Page

. Large eddy simulation of a controlled diffusion compressor cascade. Flow, Turbulence and Combustion 2011; 86: 207–230.

15.

Tauveron

. Simulation of a compressor cascade with stalled flow using Large Eddy Simulation with two-layer approximate boundary conditions. Nucl Eng and Des 2010; 240(2): 321–335.

16.

Kato

Mukai

Manabe

. Large-eddy simulation of unsteady flow in a mixed-flow pump. Int J Rotating Machinery 2003; 9(5): 345–351.

17.

Posa

Lippolis

Balaras

. Large-eddy simulation of a mixed-flow pump at off-design conditions. J Fluids Eng 2015; 137(10): 101302.

18.

Bogey

Bailly

. Large eddy simulations of transitional round jets: Influence of the Reynolds number on flow development and energy dissipation. Phys Fluids 2006; 18(6): 065101.

19.

Esfahani

Modirkhazeni

Mohammadi

. Accuracy analysis of predicted velocity profiles of laminar duct flow with entropy generation method. Appl Maths Mech 2013; 34(8): 971–984.

20.

Jia

Liu

. Loss sources analysis of shroud leakage flow in highly-loaded turbine. J Propulsion Tech 2014; 35(1): 33–42.

21.

Kluxen

Behre

Jeschke

, et al. Loss mechanisms of interplatform steps in a 1.5-stage axial flow turbine. J Turbomach 2017; 139(3): 031007.

22.

Zeinalpour

Mazaheri

. Entropy minimization in turbine cascade using continuous adjoint formulation. Eng Optimization 2015; 48(2): 213–230.

23.

Pedersen

Larsen

Jacobsen

. Flow in a Centrifugal Pump Impeller at Design and Off-Design Conditions-Part I: Particle Image Velocimetry (PIV) and Laser Doppler Velocimetry (LDV) Measurements. J Fluids Eng 2003; 125(1): 61–72.

24.

Vasilyev

Goldstein

DeStefano

, et al. Lagrangian dynamic SGS model for stochastic coherent adaptive large eddy simulation. J Turbulence 2008; 9(11): 1–14.

25.

Herwig

Kock

. Direct and indirect methods of calculating entropy generation rates in turbulent convective heat transfer problems. Heat Mass Transfer 2007; 43(3): 207–215.