Piezoceramic Composite Actuators for Flow Control in Low Reynolds Number Airflow

Abstract

The research presented here employs solid-state actuators for flow separation delay or for forced attachment of separated flow seen in airfoils at low Reynolds numbers. To reduce separation, periodic excitation to the flow around the leading edge of the airfoil is induced by Macro-Fiber Composite actuated clamped-free unimorph benders. An electromechanical model of the unimorph is briefly presented and parametric study is conducted to aid the design of a unimorph to output high deformation at a desired frequency. The optimum frequency and amplitude for lift improvement at post-stall angles are identified experimentally. Along with aerodynamic force and structural displacement measurements, helium bubble flow visualization is used to verify existing separated flow, and the attached flow induced by flow control. The lift enhancement induced by several flow control techniques is compared. A symmetric and non-uniform (3D) flow excitation results in the maximum lift enhancement at post-stall region at the lowest power consumption level. A maximum lift coefficient increase of 27.5% (in the post-stall region) is achieved at 125 Hz periodic excitation, with the 3D symmetric actuation mode at 5 m/s and the reduced frequency of 3.78. C_{l, max} is increased 7.6% from the baseline.

Keywords

flow control NACA 0010 airfoil low Reynolds number unimorph actuator MFC.

References

Acharya, M. , Emo, S. , Bugajski, D. and Williams, D. 2004. ‘‘Smart Vanes for UCAV Engine Applications’’ , In: 2nd AIAA Flow Control Conference, 28 June to 1 July 2004, Portland, Oregon, AIAA2004-2516.

Aiaa. 1995. AIAA Standard on Assessment of Experimental Uncertainty with Application to Wind Tunnel Testing, S-071A1995, AIAA, New York.

Allen, H.J. and Vincenti, W.G. 1944. ‘‘Wall Interference in a Two-dimensional Flow Wind Tunnel with Consideration of the Effect of the Compressibility’’ , NACA TR, 782.

Barlow, J.B. , Rae Jr., W.H. and Pope, A. 1999. Low-speed Wind Tunnel Testing, 3rd edn, John Wiley & Sons, New York.

Bilgen, O. , Erturk, A. and Inman, D.J. 2010b. ‘‘Analytical and Experimental Characterization of Macro-Fiber Composite Actuated Thin Clamped-Free Unimorph Benders,’’ ASME Journal of Vibration and Acoustics 2010 (in press).

Bilgen O. , Erturk, A. , Inman, D.J. and Kochersberger, K.B. 2008. ‘‘Macro-Fiber Composite Actuated Thin Clamped-Free Benders and Thin Simply-supported Morphing Airfoils,’’ In: 19th International Conference on Adaptive Structures and Technologies , 6-9 October, Ascona, Switzerland.

Bilgen, O. , Kochersberger, K.B. and Inman, D.J. 2010a. ‘‘Novel, Bi-directional, Variable Camber Airfoil Via Macro-Fiber Composite Actuators,’’ AIAA Journal of Aircraft, 47:303-314.

Erturk, A. , Bilgen O. , Fontenille, M. and Inman, D.J. 2008. ‘‘Piezoelectric Energy Harvesting from Macro-Fiber Composites with an Application to Morphing-wing Aircrafts’’ , In: 19th International Conference on Adaptive Structures and Technologies, 6-9 October, Ascona, Switzerland.

Erturk, A. and Inman, D.J. 2008. ‘‘A Distributed Parameter Electromechanical Model for Cantilevered Piezoelectric Energy Harvesters,’’ ASME Journal of Vibration and Acoustics, 130:041002.

10.

Fox, R.W. , McDonald, A.T. and Pritchard, P.J. 2004. Introduction to Fluid Mechanics, 6th edn, John Wiley & Sons, New York.

11.

Gad-el-Hak, M. 1990. ‘‘Control of Low-Speed Airfoil Aerodynamics ,’’ AIAA Journal, 28:1537-1552.

12.

Glezer, A. , Amitay, M. and Honohan, A. 2005. ‘‘Aspects of Low- and High-frequency Actuation for Aerodynamic Flow Control,’’ AIAA Journal, 43:1501-1511.

13.

Gomes, L.D. , Crowther, W.J. and Wood, N.J. 2006. ‘‘Towards a Practical Piezoceramic Diaphragm Based Synthetic Jet Actuator for High Subsonic Applications - Effect of Chamber and Orifice Depth on Actuator Peak Velocity,’’ In: 3rd AIAA Flow Control Conference, AIAA 2006-2859, 5-8 June, San Francisco, California.

14.

Greenblatt, D. and Wygnanski, I.J. 2000. ‘‘The Control of Flow Separation by Periodic Excitation,’’ Progress in Aerospace Sciences , 36:487-545.

15.

Hagood, N.W. , Kindel, R. , Ghandi, K. and Gaudenzi, P. 1993. ‘‘Improving Transverse Actuation using Interdigitated Surface Electrodes,’’ In: North American Conference on Smart Structures and Materials, SPIE Paper No. 1917-25, Albuquerque, NM.

16.

Inman, D.J. and Cudney, H.H. 2000. ‘‘Structural and Machine Design Using Piezoceramic Materials: A Guide for Structural Design Engineers,’’ Final Report, NASA Langley Grant NAG-1-1998.

17.

Joslin, R.D. 1998. ‘‘Aircraft Laminar Flow Control,’’ Annual Review of Fluid Mechanics, 30:1-29.

18.

Maskell, E.C. 1965. ‘‘A Theory of the Blockage Effects on Bluff Bodies and Stalled Wings in a Closed Wind Tunnel,’’ Aeronautical Research Council Reports and Memoranda, ARC R&M-3400.

19.

Ohanian, O. , Karni, E. , Londenberg, W. , Gelhausen, P. and Inman, D.J. 2009. ‘‘Ducted-fan Force and Moment Control Via Steady and Synthetic Jets,’’ In: 27th AIAA Applied Aerodynamics Conference, AIAA Paper No. 2009-3622, 22-25 June, San Antonio, Texas.

20.

Patel, M.P. , Ng, T.T. , Vasudevan, S. , Corke, T.C. and He, C. 2007. ‘‘Plasma Actuators for Hingeless Aerodynamic Control of an Unmanned Air Vehicle,’’ Journal of Aircraft, 4:1264-1274.

21.

Pern, N.J. , Jacob, J. and LeBeau, R. 2006. ‘‘Characterization of Zero Mass Flux Flow Control for Separation Control of an Adaptive Airfoil,’’ In: 36th Fluid Dynamics Conference, AIAA Paper 2006-3032, 5-8 June, San Francisco, California, USA.

22.

Ramakumar, K. and Jacob, J. 2005. ‘‘Flow Control and Lift Enhancement Using Plasma Actuators,’’ In: 35th Fluid Dynamics Conference, AIAA Paper 2005-4635, 6-9 June, Toronto, Ontario, Canada.

23.

Rogers, E. , Schwartz, A. and Abramson, J. 1985. ‘‘Applied Aerodynamics of Circulation Control Airfoils and Rotors,’’ Annual Forum Proceedings of the American Helicopter Society, 2:479-490.

24.

Santhanakrishnan, A. , Pern, N.J. , Ramakumar, K. , Simpson, A. and Jacob, J.D. 2005. ‘‘Enabling Flow Control Technology for Low Speed UAVs,’’ In: Infotech@Aerospace , AIAA 2005-6960, 26-29 September, Arlington, Virginia.

25.

Seifert, A. , Greenblatt, D. and Wygnanski, I.J. 2000. ‘‘Active Separation Control: An Overview of Reynolds and Mach Numbers Effects,’’ Aerospace Science and Technology, 8:569-582.

26.

Wilkie, W.K. , Bryant, G.R. and High, J.W. 2000. ‘‘Low-cost Piezocomposite Actuator for Structural Control Applications,’’ In: SPIE 7th Annual International Symposium on Smart Structures and Materials , Newport Beach, CA.