Measurements of in-cylinder mixture strength and fuel accumulation in the inlet port of a gasoline - injected engine during very rapid throttle openings

Abstract

The mixture strength in a cylinder of a port-injected gasoline engine was monitored continuously during very rapid throttle openings. The data on mixture strength were combined with other engine data collected in order to obtain for each successive engine cycle: the air—fuel ratio within the cylinder and the change in the fuel mass accumulating on the inlet port of the cylinder being monitored.

The four-cylinder spark-ignition engine used had a displacement of 1.6 litre, four valves per cylinder and multipoint sequential fuel injection controlled by an electronic management system programmed for three - way catalyst operation. All tests were conducted with the engine coolant at the temperature of 90°C and at a constant engine speed of 2000 r/min. The engine transient involved very rapid throttle openings which were completed within about 15 ms. Small and large throttle openings were investigated along with the effect of altering the type and condition of the fuel injectors.

The engine response to the fast throttle opening comprised a sharp rise in the air—fuel ratio (maximum gravimetric air—fuel ratio of around 25:1) which lasted for only a single cycle, followed by a drop in the air-fuel ratio (minimum air—fuel ratio of about 10:1) and, subsequently, a gradual rise towards a stoichiometric air—fuel ratio within about 10 engine cycles.

Keywords

spark ignition engines mixture preparation fuel injection load transients air—fuel ratio inlet fuel film in-cylinder measurements

Get full access to this article

View all access options for this article.

References

Rose

Ladommatos

Stone

In-cylinder mixture excursions in a port-injected engine during fast throttle opening. SAE paper 940382, 1994.

Aquino

C. F.

Transient A/F control characteristics of the 5 liter central fuel injection engine. SAE paper 810494, 1981.

Hires

S. D.

Overington

M. T.

Transient mixture strength excursions—an investigation of their causes and the development of a constant mixture strength fuelling strategy. SAE paper 810494, 1981.

Milton

B. E.

Behnia

A Numerical Study of the Interchanging Vapor, Droplet, and Film Flows in a Gasoline Engine Manifold. Heat and Mass Transfer in Gasoline and Diesel Engines, 1989 (Hemisphere Publishing Corporation, New York).

Miller

M. J.

Nightingale

C. J. E.

Measurement of the changes in mixture preparation that occur during flow past the inlet valve of a spark-ignition engine. In IMechE Conference, 1990, paper C394/004 (Mechanical Engineering Publications, London).

Brown

C. N.

Mixture preparation in a fuel injected spark-ignition engine at low load and low speed. PhD thesis, Brunel University, 1991.

Nakamura

Nomura

Suzuki

Key factors of fuel injection system to draw out good response in 4-valve engine. SAE paper 870126, 1987.

Benninger

N. F.

Plapp

Requirements and performance of engine management systems under transient conditions. SAE paper 910083, 1991.

Tanaka

Durbin

E. J.

Transient response of a carburettor engine. SAE paper 770046, 1977.

10.

Aquino

C. F.

Plensdorf

W. D.

An evaluation of local heating as a means of fuel evaporation for gasoline engines. SAE paper 860246, 1986.

11.

Iwata

Furuhashi

Ujihasi

Two-hole injector improves transient performance and exhaust emissions of 4-valve engines. SAE paper 870125, 1987.

12.

Namiyama

Nakamura

Kokubo

Hosogai

Development of ultrasonic atomizer and its application to S.I. engines. SAE paper 890430, 1989.

13.

Shayler

P. J.

Teo

Y. C.

Scarisbrick

Determining fuel transfer characteristics for mixture control during transient operation. In IMechE Seminar on Worldwide Engine Emission Standards and How to Meet Them, London, 25–26 May 1993.

14.

Hendricks

Jensen

Kaidantzis

Rasmussen

Vesterholm

Transient A/F ratio errors in conventional SI engine controllers. SAE paper 930856, 1993.

15.

Turin

R. C.

Casartelli

E. G. B.

Geering

H. P.

A new model for fuel supply dynamics in a SI engine. SAE paper 940208, 1994.

16.

C. F.

Duan

Q. C.

Maroteaux

Murat

Time resolved measurements of fuel transient behaviour and cycle to cycle variation of local fuel/air equivalence ratio in gasoline engines. SAE paper 940989, 1994.

17.

Ladommatos

Rose

Monitoring of the mixture strength in the cylinders of a port-injected gasoline engine during transient operation. Proc. Instn Mech. Engrs, Part D, Journal of Automobile Engineering, 1995, 209(D2), 127–134.

18.

Brown

C. N.

Ladommatos

The effects of mixture preparation and trapped residuals on the performance of a spark-ignition engine with air-shrouded port injectors, at low load and low speed. Proc. Instn Mech. Engrs, Part D, Journal of Automobile Engineering, 1991, 205(D1), 17–30.

19.

Rose

Mixture preparation in a spark-ignition engine during fast load transients. PhD thesis, Brunei University, 1994.

20.

Rassweiller

G. M.

Withrow

Motion pictures of engine flames correlated with pressure cards. SAE paper 800131, 1980.

21.

Heywood

J. B.

Internal Combustion Engine Fundamentals, 1988, Ch. 5 (McGraw-Hill, New York).