Abstract
This paper explores technical and other issues arising from using shaped timber for a 1 metre long high efficiency blade for a small 600 W wind turbine. Two readily available Australian grown softwood timber species, radiata pine and hoop pine, were selected. Reasons for selecting these timbers are detailed in the paper. The fatigue life of the both timbers was determined using four point flexural testing. Results show that hoop pine is 25% stronger and 6% more fatigue resistant than radiata pine. A fatigue test procedure for the 1 m blade has been created based on the aeroelastic response of a 2.5 m long composite wind turbine blade and wind data from the Australian Bureau of Meteorology. Blade fatigue-life predictions, using Miners rule for fatigue damage accumulation, indicated effectively unlimited fatigue-life for a blade constructed from hoop pine, with the turbine operating at design performance in wind speeds up to 20 m/s. The blade's life was reduced to a few months when it was constructed from radiata pine for the same operating conditions to 20 m/s. However for an upper wind speed of 17 m/s, the predicted blade fatigue-life is effectively unlimited for both species. Test blades were machined in both radiata pine and hoop pine on a 3-axis milling machine with tool paths created using Pro/Manufacture software. Some of the important issues with respect to creating the blades out of timber are discussed.