A passive structural health monitoring (SHM) system for locating foreign-object impact using a network of fiber Bragg grating (FBG) sensors that monitor high frequency dynamic strains is described. The FBG sensor signals are adaptively demodulated using a two-wave mixing (TWM) spectral demodulator. Strains applied on the FBG sensors are encoded as wavelength shifts of the light reflected by the FBG sensor which are then converted into phase shifts and demodulated by the TWM interferometer. The demodulator adaptively compensates for low frequency drifts caused by large quasi-static strain and temperature drift and allows only high frequency signals to pass through. The FBG sensor network is mounted on a plate, and the structure is subjected to artificial impacts generated by dropping small ball bearings. Owing to the directional sensitivity of the FBG sensors, an FBG sensor-pair configuration is used at each sensing location. The impact signals from multiple FBG sensors are simultaneously acquired at frequencies of up to 180kHz. Using time-frequency wavelet analysis, the group velocity dispersion curve of the detected Lamb wave modes is obtained from the measured transient responses of the sensors, and this is used to determine the location of the impact.
Park, H.W., Sohn, H., Law, K.H. and Farrar, C.R. ( 2007). Time reversal active sensing for health monitoring of a composite plate. Journal of Sound and Vibration, 302, 50-66.
2.
Park, G., Farrar, C.R., Scalea, F.L. and Coccia, S. ( 2006). Performance assessment and validation of piezoelectric active-sensor in structural health monitoring. Smart Materials and Structures, 15, 1673-1683.
3.
Kirikera, G.R., Sun, L., Kil, H.G., Achenbach, J.D. and Krishnaswamy, S. ( 2008). Matched ultrasonic transducers and assessment of transducer performance for robust structural health monitoring applications. In: Thompson, D.O. and Chimenti, D.E. (eds), CP975, Review of Quantitative Nondestructive Evaluation, Vol. 27, pp. 1436-1444, Golden, CO: American Institute of Physics.
4.
Petculescu, G., Krishnaswamy, S. and Achenbach, J.D. (2008). Group delay measurements using modally selective Lamb wave transducers for detection and sizing of delaminations in composites. Smart Materials and Structures , 17, 015007.
5.
Kirikera, G.R. , Shinde, V., Schulz, M.J., Ghoshal, A., Sundaresan, M.J., Allemang, R.J. and Lee, J.W. (2008). A structural neural system for real-time health monitoring of composite materials. Structural Health Monitoring, 7, 65-83.
6.
Hamstad, M.A. ( 2000). Thirty years of advances and some remaining challenges in the application of acoustic emission in composite materials. In: Kishi, T., Ohtsu, M. and Yuyama, S. (eds), Acoustic Emission - Beyond the Millenium, pp. 77-91, Oxford: Elseiver.
7.
Wells, R., Hamstad, M.A. and Mukherjee, A.K. ( 1983). On the origin of the first peak of acoustic emission in 7075 aluminum alloy. Journal of Materials Science, 18, 1015-1020.
8.
Prosser, W.H. ( 1991).The propagation characteristics of the plate modes of acoustic emission waves in thin aluminum plates and thin graphite/epoxy composite plates and tubes. PhD Dissertation, NASA Technical Memorandum104187.
9.
Gorman, M.R. (1991). Plate wave acoustic emission . Journal of Acoustical Society of America, 90(1), 358-364.
10.
Dunegan, H.L. (1997). Modal analysis of acoustic emission signals, DECI Newsletters and Reports, October.
11.
Kirikera, G.R. , Shinde, V., Schulz, M.J., Sundaresan, M.J., Hughes, S., vanDam, J., Nkrumah, F., Grandhi, G. and Ghoshal, A. (2008). Monitoring multi-site damage growth during quasi-static testing of a wind turbine blade using a structural neural system. Structural Health Monitoring, 7, 157-173.
12.
Qiao, Y., Zhou, Y. and Krishnaswamy, S. ( 2006). Adaptive demodulation of dynamic signals from fiber Bragg gratings using two-wave mixing technology. Applied Optics , 45, 5132-5142.
13.
Seim, H., Udd, E., Schulz, W., MacMohon, R., Soltesz, S. and Laylor, M. ( 2000). Development and deployment of fiber optic highway and bridge monitoring systems. In: Aktan, A.E., Gosselin S.R. (eds), Proceedings of SPIE - Nondestructive Evaluation of Highways, Utilities and Pipelines IV, June, Vol. 3995, pp. 479-482. Available at: http://spie.org/x648.html?product_id=387840 (accessed March 12, 2010).
14.
Ansari, F. ( 1998). Fiber Optic Sensors for Construction Materials and Bridges . Lancaster, PA: Technomic Publishing Co.
15.
Takeda, S., Yamamoto, T., Okabe, Y. and Takeda, N. ( 2007). Debonding monitoring of composite repair patches using embedded small-diameter FBG sensors. Smart Material and Structures , 16, 763-770.
16.
Fomitchov, P. and Krishnaswamy , S. (2003). Response of a fiber bragg grating ultrasonic sensor. Optical Engineering, 42, 956-963.
17.
Betz, D.C., Thursby, G., Culshaw, B. and Staszewski, W.J. ( 2007). Structural damage location with fiber bragg grating rosettes and lamb waves. Structural Health Monitoring, 6, 299-308.
18.
Othonos, A. and Kalli, K. ( 1999). Fiber Bragg Gratings - Fundamentals and Applications in Telecommunications and Sensing. Boston, MA: Artech House Publishers.
19.
Kersey, A.D. , Berkoff, T.A. and Morey, W.W. (1993). Multiplexed fiber Bragg grating strain-sensor system with a Fabry-Perot wavelength filter. Optics Letters, 18, 1370-1372.
20.
Xu, M., Geiger, G.H. and Dakin, J.P. ( 1993). Modeling and performance analysis of a fiber Bragg grating interrogation system using an acousto-optic tunable filter. IEEE Journal of Lightwave Technology, 14, 391-396.
21.
Ball, G.A., Morey, W.W. and Cheo, P.K. ( 1994). Fiber laser source/analyzer for Bragg-grating sensor array interrogation. IEEE Journal of Lightwave Technology , 12, 700-703.
22.
Davis, M.A. and Kersey, A.D. (1995). Application of a fiber Fourier Transform spectrometer to the detection of wavelength encoded signals from Bragg-grating sensors. IEEE Journal of Lightwave Technology , 13, 1289-1295.
23.
Kersey, A.D. , Berkoff, T.A. and Morey, W.W. (1992). High resolution fiber-grating based strain sensor with interferometric wavelength shift detection. Electronics Letters, 28, 236-238.
24.
Qiao, Y. ( 2006) Adaptive demodulation of dynamic signals from fiber Bragg grating sensors using two-wave mixing interferometry in indium phosphide: iron. PhD Dissertation, Northwestern University.
25.
Solymar, L., Webb, D.J. and Grunnet-Jepsen, A. ( 1996). The Physics and Applications Of Photorefractive Materials . New York: Oxford University Press .
26.
Delaye, P., Blouin, A., Drolet, D., Montmorillon, L., Rosen, G. and Monchalin, J.P. ( 1997). Detection of ultrasonic motion of a scattering surface by photorefractive InP:Fe under an applied dc field. Journal of the Optical Society of America B, 14, 1723-1734.
27.
Takemoto, M., Nishino, H. and Ono, K. ( 2000). Wavelet transform - applications to AE signal analysis . In: Kishi, T., Ohtsu, M. and Yuyama, S. (eds), Acoustic Emission - Beyond the MILLENNIUM, pp. 35-56, Amsterdam: Elsevier.
